2010 Chevrolet Camaro 1Lt

Official recalls

• Electrical System

  General Motors LLC (GM) is recalling certain replacement flip-key ignition transmitter assemblies sold as replacement equipment for 2010-2015 Chevrolet Camaro vehicles. GM dealers may have inadvertently sold these assemblies as replacement keys despite them having been recalled under NHTSA recall number 14V-346 (GM number 14294) when they were the original equipment assemblies. The driver may accidentally bump the ignition key with their knee, moving the ignition out of the run position and turning off the engine.

  Remedy: GM will notify owners, and dealers will inspect and, as necessary, replace the key with the flat blade design, free of charge. Interim notices informing owners of the safety risk were mailed November 6, 2019. Owners received a second notice and the recall began February 4, 2020. Owners may contact Chevrolet customer service at 1-800-222-1020. GM's number for this recall is N192223230.

  NHTSA campaign: 19E064000

• Electrical System

  General Motors LLC (GM) is recalling all 2010-2014 Chevrolet Camaro vehicles manufactured December 3, 2008 to May 23, 2014. In the affected vehicles, the driver may accidentally hit the ignition key with their knee, unintentionally knocking the key out of the run position, turning off the engine.

  Remedy: GM will notify owners, and dealers will remove the key blade from the original flip key/RKE transmitter assemblies, and provide two new keys and two key rings per key. The recall began August 25, 2014. Owners may contact Chevrolet customer service at 1-800-222-1020. GM's number for this recall is 14294. Note: Until the recall has been performed, it is very important that drivers adjust their seat and steering column to allow clearance between their knee and the ignition key.

  NHTSA campaign: 14V346000

• Electrical System

  GM IS RECALLING 1,243 MY 2010 CHEVROLET CAMARO EQUIPPED WITH A V8 ENGINE. THE POSITIVE BATTERY CABLE MAY CONTACT THE STARTER MOTOR HOUSING AND CAUSE WEAR ON THE CABLE INSULATION. IF THE INSULATION WEARS THROUGH TO THE CABLE, IT COULD CREATE A SHORT.