2011 Chevrolet Colorado 1Lt

Official recalls

• Visibility

  GENERAL MOTORS IS RECALLING CERTAIN MODEL YEAR 2011 CHEVROLET COLORADO AND GMC CANYON VEHICLES MANUFACTURED FROM SEPTEMBER 22, 2010, THROUGH NOVEMBER 5, 2010. SOME OF THESE VEHICLES HAVE THE CONDITION IN WHICH THE WINDSHIELD WIPER MOTOR CRANK ARM NUT MAY NOT BE TIGHTENED TO SPECIFICATION. WHEN THE WIPERS ARE OPERATED WITH A BUILD-UP OF SNOW OR ICE, OR IF THE WIPERS ARE OPERATED ON A DRY WINDSHIELD, THE NUT COULD LOOSEN. IF THERE IS SUFFICIENT LOOSENING OF THE NUT, THE WIPERS COULD BECOME INOPERATIVE.

  Remedy: DEALERS WILL SECURE THE WIPER MOTOR CRANK ARM NUT FREE OF CHARGE. THE SAFETY RECALL IS EXPECTED TO BEGIN ON OR BEFORE MAY 11, 2011. OWNERS MAY CONTACT CHEVROLET AT 1-800-630-2438, GMC AT 1-866-996-9463 OR WWW.GMOWNERCENTER.COM.

  NHTSA campaign: 11V276000

• Latches/Locks/Linkages

  General Motors is recalling certain model year 2010-2012 Chevrolet Colorado and GMC Canyon vehicles manufactured from November 9, 2009, through August 28, 2012, for failing to comply with the requirements of Federal Motor Vehicle Safety Standard No. 113, "Hood Latch System." The hood may be missing the secondary hood latch.

  Remedy: General Motors will notify owners and instruct them to inspect their vehicle for the presence of a secondary hood latch. Dealers will replace the hood on any affected vehicles, free of charge. The recall is expected to begin on January 17, 2013. Owners may contact Chevrolet at 1-800-630-2438 or GMC at 1-866-996-9463.

  NHTSA campaign: 12V594000

• Power Train

  GENERAL MOTORS IS RECALLING CERTAIN MODEL YEAR 2011 CHEVROLET COLORADO AND GMC CANYON PASSENGER VEHICLES EQUIPPED WITH A 2.9 OR 3.7 LITER ENGINE AND A FOUR-SPEED AUTOMATIC TRANSMISSION FOR FAILING TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO 102, "TRANSMISSION SHIFT LEVER SEQUENCE, STARTER INTERLOCK, AND TRANSMISSION BRAKING EFFECT," AND FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 114, "THEFT PROTECTION." THESE VEHICLES MAY HAVE BEEN BUILT WITH AN AUTOMATIC TRANSMISSION ADJUSTMENT CLIP THAT MAY NOT RETAIN THE SHIFT CABLE IN THE CORRECT POSITION. IF THE SHIFT CABLE IS NOT IN THE CORRECT POSITION, THE PRNDL SHIFT LEVER MAY NOT ACCURATELY REFLECT THE POSITION OF THE TRANSMISSION GEAR. THE DRIVER COULD MOVE THE SHIFTER TO "PARK" AND REMOVE THE IGNITION KEY, BUT THE TRANSMISSION GEAR MAY NOT BE IN "PARK."