1994 Chevrolet Cavalier Vl/Rs

Official recalls

• Electrical System

  THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH FEDERAL REGULATION 573. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. THESE VEHICLES WERE BUILT WITH INSUFFICIENT RETENTION OF THE HORN PAD.

  Consequence: THE HORN PAD CAN SEPARATE FROM THE STEERING WHEEL FALLING BETWEEN THE STEERING WHEEL SPOKES. THE HORN PAD COULD BECOME JAMMED BETWEEN THE STEERING WHEEL SPOKES AND THE TURN SIGNAL LEVER, RESULTING IN DAMAGE TO THE TURN SIGNAL LEVER, HORN PAD, AND HORN WIRING.

  Remedy: DEALERS WILL MODIFY THE HORN PAD RETENTION CLIPS, INSTALL HORN PAD RETENTION BRACKETS TO THE STEERING WHEEL, REINSTALL THE HORN PAD AND ASSURE THAT THE HORN PAD IS PROPERLY RETAINED.

  NHTSA campaign: 96I001000 · 1996-01-23

• Steering

  THESE VEHICLES WERE BUILT WITH OVERTORQUED DRIVE AXLE SPINDLE NUTS. THIS CONDITION CAN CAUSE EXCESSIVE LOADS ON THE SPINDLE NUT AND DRIVE AXLE RESULTING IN FAILURE OF THE DRIVE AXLE OR THE SPINDLE NUT. FAILURE OF EITHER OF THESE COMPONENTS CAN RESULT IN SEPARATION OF THE STEERING KNUCKLE TIRE-WHEEL ASSEMBLY FROM THE DRIVE AXLE.

  Consequence: THIS CAN RESULT IN LOSS OF VEHICLE CONTROL AND A VEHICLE ACCIDENT.

  Remedy: DEALERS WILL REPLACE THE LEFT-HAND AND RIGHT-HAND DRIVE AXLES, BEARING-HUB ASSEMBLIES, SPINDLE NUTS, AND WASHERS ON ALL INVOLVED VEHICLES. CORRECTIVE ACTION: DEALERS WILL REPLACE LEFT-HAND AND RIGHT-HAND DRIVE AXLES, BEARING-HUB ASSEMBLIES, SPINDLE NUTS, AND WASHERS ON ALL INVOLVED VEHICLES.

  NHTSA campaign: 94V115000 · 1994-06-24