2007 Jeep Commander Limited

Official recalls

• Electrical System

  This defect can affect the safe operation of the airbag system. Until this recall is performed, drivers should adjust their seat to allow clearance between the driver's knee and the ignition key, and remove all items from their key ring, leaving only the vehicle key. Chrysler Group LLC (Chrysler) is recalling certain model year 2005-2007 Jeep Grand Cherokee vehicles manufactured February 11, 2004, to July 5, 2007, and 2006-2007 Jeep Commander vehicles manufactured January 31, 2005, to July 5, 2007. In the affected vehicles, the driver may accidentally hit the ignition key with their knee, unintentionally knocking the key out of the run position, turning off the engine.

  Remedy: Chrysler will notify owners, and dealers will replace the ignition switch, free of charge. Chrysler sent interim notifications to owners in September 2014. The recall began on October 9, 2015. Owners may contact Chrysler customer service at 1-800-853-1403. Chrysler's number for this recall is P41.

  NHTSA campaign: 14V438000

• Power Train

  Chrysler Group LLC (Chrysler) is recalling certain model year 2005-2010 Jeep Grand Cherokee vehicles manufactured February 11, 2004, through March 9, 2010; and 2006-2010 Jeep Commander vehicles manufactured January 31, 2005, through March 10, 2010. A transfer case electrical failure may result in an unintentional shifting of the transfer case into the neutral position.

  Remedy: Chrysler will notify owners, and dealers will reflash the final drive controller which governs the transfer case, with new software, free of charge. The recall began on August 15, 2013. Owners may contact Chrysler at 1-800-247-9753. Chrysler's recall campaign number is N23.

  NHTSA campaign: 13V175000

• Suspension

  ROCK KRAWLER IS RECALLING 44 PERFORMANCE SUSPENSION SYSTEMS SOLD AS AFTERMARKET EQUIPMENT FOR USE ON THE VEHICLE LISTED ABOVE. THESE SUSPENSION SYSTEMS WERE PRODUCED WITH GRADE 2 CARRIAGE BOLTS INSTEAD OF THE PROPER GRADE 5 CARRIAGE BOLTS. THE IMPROPER GRADE 2 CARRIAGE BOLTS COULD EXPERIENCE A LOSS OF CLAMPING FORCE FOR THE BOTTOM STRUT FORK.